Hei conversion from pints need help... what am I doing wrong.

I do not have a mopar Ecu. It’s stock mopar points ignition. Using 4 pin hei module. Wiring comes from Mopar HEI Conversion. Which is where I got the bracket from. I did not bypass the ballast resistor. Since I’m still running the stock canister coil I need the resistor. Once I swap to the ecoil I will bypass the ballast resistor. But I don’t want to do too many swaps at once until I know this hei conversion works.

I will try to swap wires that are powering the hei module that I ran to my coil.