? about that 3.65” crank

Thanks, (obviously) I wasn’t thinking out of the box which I normally at least think about that route for a moment or two. I wasn’t thinking about another manufactures piston ether. Weird because this comes up at work every now and again between the motor heads.

No rods yet. The crank was part of a package deal. The pistons were also included. But there a 4.03 bore size and the crank is for the smaller mains. Being that I have a lot on my plate in front of me to do engine wise, I have not bothered to entertain thoughts on the cranks use yet. I still have 2 more 340 blocks to sonic check for Potential use.

I have in front of me a pair of 340 blocks that are reasonable for use. 1 for the 3.58 stroke crank, 1 for the 4 inch (or 4+) arm build.