1966 Barracuda carpet - real world feedback
I laid the carpet outside in the sun a few hours to "soften" it up. When triming the sides by the sills I only cut a little at a time. Didn't want to cut too much. To do holes for the seatbelts and dimmer switch I first cut with a blade, then singed with a solder iron. The cargo wheel wells were the most challenging for me. I used 3M spay adhesive (I think) for the areas that needed attached. I only found one after pic and it's not that good.
The mice had made a nest under the cargo "floor panel". The fuel sender wire ran right through it and they must have been hungry!!
I laid the carpet outside in the sun a few hours to "soften" it up. When triming the sides by the sills I only cut a little at a time. Didn't want to cut too much. To do holes for the seatbelts and dimmer switch I first cut with a blade, then singed with a solder iron. The cargo wheel wells were the most challenging for me. I used 3M spay adhesive (I think) for the areas that needed attached. I only found one after pic and it's not that good.
The mice had made a nest under the cargo "floor panel". The fuel sender wire ran right through it and they must have been hungry!!
