Magnum replacement heads

The seat work sure looks very similar to:

View attachment 1715507088

View attachment 1715507089

Unless it’s a very stock type build, I’d suggest a little clean up in the bowls.

It’s hard to imagine they’d be any worse for a “mild performance” build than stock magnum heads.
So, if you think stock heads(or tweaked stock heads) would get you were you wanna be.......I would imagine those will as well.

Unless you can get one flowed, and have some numbers from a stock head from the same bench....... it’s all speculation as to how good or bad those are.

The EQ’s were a noticeable improvement over an OE magnum head.
Thanks, I appreciate the input! I am not sure why there is a big step above the valve seat, almost like its counter bored down to far. It shrouds the valve pretty bad. Guides are pretty loose too, looks like .316, and the stem is .312 on the dot. I can fix the issues with guide liners and some seat work, but still concerned about the short turn