Small Block Cam Info - Magnum Head Swap

Thanks! I'm setting my expectations low so I'm not disappointed, it is such a dog right now.

Used this graph to compare the cam's once I picked a few that worked, it was pretty interesting to visually see the lobe separation, duration and when the valves open and close for the different grinds.
Camshaft Calculator & Valve Overlap Profiles | MGI SpeedWare

I've referenced a few builds online and some engine masters episodes to help my cam selection, these were much higher RPM engines than what I'll be building and flowed much better.
https://www.hotrod.com/articles/318-small-block-build/
318 Engine Build - A Parts Book 400HP 318 - Mopar Muscle Magazine - Hot Rod

Ep:53 (I had the same thought about selecting a cam based on the intake valve closing sooner to raise compression but they showed static compression doesn't matter near as much as air moving through the heads. I compared the cam used in that video to a few I was looking at for comparison, Comp Cams 21-600-5)
ENGINE MASTERS: Season 4, Episode 53 - The 440 You Can Afford | MotorTrend
Ep:58 (This is where they actually degree'd the cam in)
ENGINE MASTERS: Season 5, Episode 58 - Advances in Cam Timing | MotorTrend