master cyl pushrod adj
I set the push rod to the spec in the service manual .940 with my dial caliper. Installed the master cyl, ready to bleed. I noticed the piston only comes back half way to the large hole in the master cyl. Is this correct, or do I need to remove the master cyl. And adjust so the piston goes back past the hole?
I set the push rod to the spec in the service manual .940 with my dial caliper. Installed the master cyl, ready to bleed. I noticed the piston only comes back half way to the large hole in the master cyl. Is this correct, or do I need to remove the master cyl. And adjust so the piston goes back past the hole?
