Must be a dash/instrument weekend. I was going to create a thread on this very subject.
Couple of things I am having issues with. See attached pics.
The first picture I have is the front of my dash with 3 screw drivers pointing to specific holes. First question regarding these holes, what kind of fasteners are used in these holes? The second picture is a closer shot of one of the holes. In the third picture you can see the back side of one of the holes where there is a tab that I am quite sure a screw threads into problem is the screws I have (which I believe may be part of the solution) would just pass through the opening unless there is some sort of washer that fits into the hole on the dash side. Also in the third picture it appears that there should be some sort of "spacer", between the tab and the plastic framing of the dash?
The forth picture is one of the screws I am speaking about. I have the same problem as Derrick the dash was partly disassembled, I found these screws in the ashtray.
In the last picture you can see I attached one of the screws to the far upper left side of the dash, the location is just above the hole where the flasher switch would go, you can see the hole from the front side in picture 1. But I don't think this is where it goes as you can see it goes quite far through the dash into the underside? Seems to me the screw should be about half the length of the one that I used.
View attachment 1715516501 View attachment 1715516502 View attachment 1715516503 View attachment 1715516504 View attachment 1715516505
