Thanks for the feedback everyone... So, here's my plan. Your additional comments are welcome.
- Sand down as much of the rattle can primer as possible stopping at 180 grit. (I know for sure i won't get it all off b/c some panels are fully covered... it does sand incredible well though)
- Spray entire car with SPI Epoxy Primer (white or grey)
- Spray entire car with 2X Urethane high build primer (SPI... or is any brand fine?)
- Block, block, and block again... stopping at 400 grit :)
- Spray entire car with thinned SPI Epoxy Primer (as a sealer) (white or grey)
- Then move on to the base/clear & buff
Car will be a bright red... looking at Viper Red or similar. Not sure if I'll use the SPI universal clear or something same brand as the base paint.
Anything I'm overlooking?
