Help identify this intake...

-
moparfan68

moparfan68

Well-Known Member
Joined
Dec 12, 2010
Messages
1,791
Reaction score
152
Location
virginia
I took this intake in on trade was told it was for a bb mopar but I haven't had much luck identifying it by the casting numbers anyone know for sure what it is?

15880347320823909644662182801299.jpg


158803478486172607569188719662.jpg


15880347983114300739269399764706.jpg


15880348220321777158792638188987.jpg


15880348445604853810560445626233.jpg


15880349178884335248198755782752.jpg
 
I'll go out on a limb and say it's a 4 bbl intake. That's the best I got. Sorry.
 
it's a Mopar M-1 big block intake, but I don't know if its for B or RB engines. It's intended as a race manifold.
 
it only has one carb bolt pattern, so I'm going to go out on a limb and assume it's for a holley dominator carb. If I had a long block BB handy, I'd measure across the valley and give you a dimension to check.
 
Part # P4532598 is a racing manifold with a special port shape for w7/w8/w9 heads and a 9.0'' deck. That's all the info I have.
 
Everyone must just skip read through ****!! pt70 nailed it. It is for the W series (excluding W5) small block race heads.
 
so if it's not for a big block where's the water passage and thermostat and the valley pan? I think it just looks narrow because it's a Dominator carb on top
 
Because the W7, 8, and 9 heads have threaded ports for separate plumbing. Race only apps. Also, fabbed plates for valley. Take a peek at the book "How to Build Big Cubic Inch Small Block Mopars". Actual title name may vary.
 
Thanks guys...I really appreciate all the help identifying the mystery intake.
 
You must log in or register to reply here.
-

Back
Top