Jeep 4.0 Cam Sensor connector or pigtail

mopar65 said

Yes the Jeep sensor uses 5V. But I dont see why you couldn't just put a resistor in line and dropped the 12V down to 5V for the cam sensor. I know Andy F sells one that uses a ford cam sensor.
You engine set up looks awesome. How did you mount your Ignition coils to your valve covers? I mean did you weld studs to your valve covers or did you drill threw them and use bolts? I just bought a set of the powder coated black Fabricated Aluminum ones for my 360 and would hate to have to grind on them. Lol
Wear are you going to mount the Nock sensors? I need to get off my Butt and start working on the wireing harness for mine.

Click to expand...

On my valve covers - First I moved the oil fill opening to the center of the cover and welded shut the hole created when I cut it out. Then, I made 8 mounting bars and drilled and tapped them at a spacing that matched the coils and welded them to the valve cover. Also then made 16 standoff tubes from 3/8 stainless fuel line - They're about 9/16" long. Bolts go through the coil heat sink, through the standoff and thread in to the mounting bar. Welds are kinda hidden under the coils.

I ordered a Ford sensor cause it sure looks like it'll fit right on the Jeep housing - we'll see.

Got the O2's fired up and working. Going to start mocking up wiring runs in the car now.

Regards,
Steve