Project “Ghost Duster”, 1970 Duster Corner Carver
Next I welded in the j-shaped plates and bent the outer side of the tube against the plate and tacked it together. I then cut the tacks off and removed the guide and fully welded the plates to the tube, inside and out, and cut the support to the desired height. Finally I dressed the outside welds and DA sanded with 60 grit to make the plates seamless and aesthetically pleasing.
Next I welded in the j-shaped plates and bent the outer side of the tube against the plate and tacked it together. I then cut the tacks off and removed the guide and fully welded the plates to the tube, inside and out, and cut the support to the desired height. Finally I dressed the outside welds and DA sanded with 60 grit to make the plates seamless and aesthetically pleasing.
