Mini Starter Nut?

-
T

TF360

Well-Known Member
Joined
Apr 25, 2014
Messages
2,505
Reaction score
909
Location
Florida
Just installed a mini-starter and the negative nut does not fit. For you guys that have already done this, what size nut is on the negative side?
 
It's metric but sorry don't remember the size. Used to know.
Measure diameter with calipers and go to hardware store or NAPA..
 
Got up off the couch and measured mine.
Small stud is definitely 4mm diameter with a 7mm head. (These are Denso starters so think Japanese.)
Large stud measured 7.05 mm but honestly I think it's 5/16"-18. I tried that size nut on the exposed threads and it seems to thread on easily. Both a 13mm and 1/2" socket fit the head.
 
Last edited:
The negative goes to ground, no negatives get screwed to the starter! Do you really know what your doing????? I venture to say otherwise, Don't burn it down!!!
 
Anybody install one recently? Tried a 4mm but its not going right on end could be marred up a little
 
take it to Homeless depot. It only weighs 8 lbs. Your "negative nut" is actually the + trigger voltage for the solenoid.

51R1FDWy06L._AC_.jpg
 
You must log in or register to reply here.
-

Back
Top