[WANTED] Slant Six Header parts and pieces needed

-
Status
Not open for further replies.
Hyper_pak

Hyper_pak

Old School Chrysler Fan
Joined
Feb 14, 2010
Messages
4,693
Reaction score
5,880
Location
Desoto Texas
Rating - 100%
26   0   0
Contact seller
I am in the header fabrication phase with my race car.
Does anyone have any headers they want to sell?
I have to cut them up and modify them.
I would rather start with some Cliffords, but what do you have?
Thanks!
 
I have a full set of flanges and a set of Clifford shorties.
Just trying to get some more good parts and bends.
Reading about design stuff now.
Thanks
 
Hyper_pak said:
I have a full set of flanges and a set of Clifford shorties.
Just trying to get some more good parts and bends.
Reading about design stuff now.
Thanks
Click to expand...
i have some here that i cant identify what it fits other than its for a slant six i will send my phone number in a pm
 
Stan, what size pipe are you going to use in building your headers. I may have some stuff you can use & I'll donate it to the cause.
 
Don, not sure yet. These Clifford are 1 1/2, 2 1/4 inch collector, I would think these are small. Hooker super comp for the slant are 1 5/8 with a 2.5 inch collector. Will sent some pictures of his old headers, they look to be closer to 1 3/4.
I was thinking about building a set with the firing order, instead of 1-2-3, 4-5-6. So they would be 1-5-3-6-2-4. Which is what the last Mopar performance header was. It was a 6x1 header. But mine would be 2 headers with a couple of slip joints.
Thank you for the offer! I will get back with you.
Wills Headers.jpeg
 
Sorry Stan, most of the tubing I have is 1 7/8" & bigger. I tried Bud, the 1-5-3-6-2-4 header should make for a very unique sound at speed.
 
Status
Not open for further replies.
-

Back
Top