Hughes heh237/242 in a 360?
Always a mystery with Hughes as they don't give you any advertised numbers from which to judge.
FWIW.... I was PM'ing with a friend here who had a Hughes hydraulic cam and had just measured it for .006" lift.... ICA increased 30* between .050" and .006". So if symmetric, then that is 60* between .050" and advertised durations. So pretty slooow down at the lower part of the ramps.
But the OP I think is asking about a solid cam.... so IDK if that same 'slowness' applies.
Lots of things that the OP needs to help us with:
- Trannie type?
- Stall of torque converter if this is an auto trannie?
- Rear gear
- Intended use of the car/engine
- Is this a stock 360, and if so, what year?
