Stop in for a cup of coffee

-
Ddaddy said:
A friend who writes articles for an on-line car magazine asked me if I could clean up an old pic of the 1973 Ford Explorer concept vehicle for one of his stories. And maybe do some other concept versions of it so he could talk about what might have been.

Sure, no problem.

Original photo...

View attachment 1715532198


Cleaned up...

View attachment 1715532199



Panel version...

View attachment 1715532200



Window version (considering it’s a ‘73 Ford concept, I picked the obvious window design)

View attachment 1715532201

If it publishes, I’ll give a link. I like the panel version...kinda cool!
Click to expand...

I must be imagining things. That interesting creation is riding on Gates Commando off road tires :realcrazy:.
Sure doesn't look like an off road kind of vehicle.
 
Rani, you can make a jumper for the inertia switch. One wire in one out couple spades and a piece of wire. Good enough to prove faulty. And sounds like a few broken wires in driver’s door jamb. I add wire to the breaks, so the repair isnt the part flexing.
 
Princess Valiant said:
Rollin rollin rollin keep those wrenches turning ..... welding welding welding, keep that metal melting.....
Towing towing towing, keep those trailers loaded.....
Twerking twerking twerking, keep those butt cheeks shaking like mr. Hoppy....
Drinking drinking drinking, keep those beers tilted like Ben drinking.....
Drawing drawing drawing, keep those pixels moving like Ddaddy.....
Juicing juicing juicing, keep juicing the orange like that font guy.....
Whining whining whining, keep on whining like......


Ok, I better stop. :rofl:
Click to expand...
Some righteous wit right there!
 
Tooljunkie said:
Rani, you can make a jumper for the inertia switch. One wire in one out couple spades and a piece of wire. Good enough to prove faulty. And sounds like a few broken wires in driver’s door jamb. I add wire to the breaks, so the repair isnt the part flexing.
Click to expand...
Dang it, why aren't you my neighbor
 
Good morning Craig and the rest off coffee club. I'm finishing a cup here before heading into work.
 
Last edited:
Morning!
Its Thunderbird thursday!
Horn wire through column was bad, had to fish a new one through. There was barely a nick in the wire, but could see where it was, stripped the wire, nice shiny copper to where wire looked pinched then copper had a few blue strands.

adjust linkage for shifter, and swing away column today. Check
State of tune and test power top.

what makes this work difficult, is the hardware holding everything together is missing, wrong or holes are stripped. So much jiggery pokery has gone on.
 
here we go again.jpg


about a bad buyer Bigboy68

Keep me out of it this time. He did pay me back.
 
Last edited:
You must log in or register to reply here.
-

Back
Top