turn signals not working

-
Tarek Baratta

Tarek Baratta

Well-Known Member
Joined
Dec 1, 2019
Messages
45
Reaction score
31
Location
Delta BC
like the titles says, my turn signals are not working, hazards work, the flasher works as swapped it with the hazards flasher, brakes, headlights, just turn signals, tested with power probe, getting power to flasher when switching switch any ideas?

Car is a 75 Plymouth valiant
 
I would agree with above^^ Try working the SHXX out of the hazard switch about 10 times and see if anything changes. But it likely is the TS switch.
 
so was messing around with wiper switch, powered one connector and heard clicking, was turn signal, the switch is working, but only when powering one terminal on my wiper switch connector, I'm guessing one shorted wire
 
Bad grounds plagued my flasher and turn signals over the years. Especially on the core support.
Worth looking at.
 
Grounding points "for what?" The only grounds in the signal/ hazard circuits really, are the lamp sockets. What you want for that is a FACTORY manual, not the 2 page aftermarket diagrams. Unfortunately, MyMopar does not have a 75 service manual.

You are likely going to have to round up a "repop" either paper manual or "on CD" if you are going to keep the car it is worth it!!
 
A lot of power goes through the turn signal switch . that being said , it can cause all kinds of issues when it comes to directional, , flashers , dome lights , back -up , and of course , brakes . Classic Industries has turn signal switch s in stock . The part # is : MD2094 and the application is '70-76 Mopar without tilt . I believe it works through all bodies . It is made by OER . $34.95 with shipping it cost me $66.99 . Arrived in 4 days . Year One has them ,also , at $96.65 . hahaha ! If you get one , you may find some of the wires are different colors , but , fear not , it only plugs in one way . good luck !
 
You must log in or register to reply here.
-

Back
Top