Stop in for a cup of coffee

-
Wear a face shield then.
Really.
Stuff spinning at 10,000 rpm is crazy enough, Don't need to take chances with disks made at the lowest cost..

Not happy the air fitting I just got from McMasters was made in China. But at least its a simple casting - and only going be used at 30 psi or less. That's another thing I don't take chances with - high pressure systems.
Already found out today when the cutting disc split I need better stuff. :D
 
Last edited:
People are planning a protest in StCloud MN. I think your close to being Ramie. Only in MN can you get arrested for opening a restaurant but not for looting and burning one
I seen that and posting a wanted ad on facebook market place for people looking to riot. That guy should be arrested and charged.
 
I just ordered a set of standard claw foot open ends, really wanted to find a curved set of regular wrenches but everything I could find was box/closed end. Will have to look at things again this weekend, haven't been in shop all week : (
 
And as you know and others may not when a law enforcement agency request NG support for crowd control (the word riot went out years ago) through state Emergency Management and authorized by the state Governor they are a law enforcement force multiplier. They are used for key asset security and traffic control. This allows law enforcement to concentrate on the problem people and areas. Usually in situations like this 5% cause 95% of the problems. NG can train for force confrontations but rarely do they engage. I don't like the look of a NG soldier standing there holding a rifle. With 33 years NG service and a couple deployments I love to see them used as they should be. With 30 years law enforcement experience 20 SWAT years, Gang Unit, DEA Task Force, and over 1200 force entry search warrants (yep I did all the fun stuff) I can tell you that rifle weapon retention is difficult unless you train daily. I'd hate to see a M-16 taken. It wouldn't be good.
Completely agree.
 
This car has not run in two years. Because it was away at George's place. Got a new guy to paint the car, next week. Had to reinstall the shifter and get a new battery. Thought maybe carb funked, but no. Made makeshift jug for fuel under the hood. Cranked before ign to be sure of oil pressure. Starts right up N.P.
 
Wow Chris it fired right up...:poke: Great job Mitch!!
I knew it... I knew someone would poke a jab. But ya gotta remember, most of you all have 100 plus years on me, you’ve had more time to figure it out :poke: :rofl:
 
127764-c5540ab4c078e27719af93e492c41c24-gif.gif
 
So the axle on ram turned into more stuff, customer isnt upset at the bill,had to be fixed. Happy he can use credit card and rack up air miles.
 
Guy shows up and hands me $30 for changing a couple tires, said he didnt forget, but was busy. I forgot. Bonus!
Sold a brake backing plate off the dead fargo diff. $40 suits me just fine.
 
Super well done guy. Congrats! Takes a lot of courage to do something like going back to school once you are middle aged. Well done good Sir!


Thanks...

I like drafting, those young kids can't put me in the weeds... They gotta be on their toes to keep up with me....
 
-
Back
Top