Cam card numbers?

nm9stheham said
If it asking for the 'Cal ID' as in the instructions near the back for the Setup Wizard Map Matrix, then go by the duration on your cam card at .050" lift....

On your cam card, that is 219 IN and 227 EX. I would go by the intake number.

Thanks. On the setup wizard it just asks " Camshaft Profile"

nm9stheham said
If it asking for the 'Cal ID' as in the instructions near the back for the Setup Wizard Map Matrix, then go by the duration on your cam card at .050" lift....

On your cam card, that is 219 IN and 227 EX. I would go by the intake number.

Thanls , What you said does make sense about going off the map matrix. The instructions say nothing about @.050 so I am still wondering.