1” FFI Torsion Bars - setting ride height

Well normally I’d say it wouldn’t drop anywhere near 2”, but since this is a brand new install of everything it will probably drop more than normal. But 2” is a lot, I doubt you’ll get anywhere near that much. The additional drop is mostly because of the change in camber as the suspension moves through its arc. The wheels hit the ground with the suspension at full compression, but then the friction of the tires on the ground resist the change in camber as the suspension compresses, which holds the suspension up some.

I suppose the next question is, how high is it sitting? What’s the distance from the floor to the middle of the wheel opening? Not sure how low you want the car to be, normally once the UCA’s are parallel to the ground you’re about as low as you want to go.

Are the adjusters loaded at the current height? I know you said they’re adjusted all the way out, but do they have tension on them? The other possibility is that something is bound up in the suspension. What type of bushings did you install? And are the bolts all fully tightened?