[WANTED] Door Panel Trim

-
Status
Not open for further replies.
jonn6464

jonn6464

1970 Duster
Joined
Mar 29, 2017
Messages
1,066
Reaction score
949
Location
Weatherford, TX
Rating - 100%
5   0   0
Contact seller
I recently found the trim piece that runs along the top of the door panel. The vinyl door panel slides up into it.

The trim continues on to the panel in the rear seat, so I'm looking for that piece on both sides.

1970 Duster.

You can see an example in this pic. It is the trim running above the arm rest, but below the "Duster" emblem. Again, I need the rear pieces.

Thanks FABO!

upload_2020-6-15_23-13-21.png
 
Anyone know if the profile of this trim is same as earlier model Darts and B'cudas? I'm pretty sure those from a B'cuda fastback will be too short. Notchback or Dart could work. Piece from doors can be cut to fit too. In some cases the piece from one door will make both of the rears. Tape measure req'd. Raw cut end needs only to land beyond the seat back.
Of course paying more for the correct pieces avoids the hack sawing and drilling screw holes. Good luck
 
These should be easy to obtain . If they are the same as Swingers even easier . I have a bunch from Swinger doors but cost of shipping would be more than their value .
 
RedFish said:
Anyone know if the profile of this trim is same as earlier model Darts and B'cudas? I'm pretty sure those from a B'cuda fastback will be too short. Notchback or Dart could work. Piece from doors can be cut to fit too. In some cases the piece from one door will make both of the rears. Tape measure req'd. Raw cut end needs only to land beyond the seat back.
Of course paying more for the correct pieces avoids the hack sawing and drilling screw holes. Good luck
Click to expand...

Yes, good point. Never thought about cutting one down to fit.
 
Status
Not open for further replies.
-

Back
Top