ring and pinion pattern check

Backlash is .0075" (.006-.008 factory spec) and pinion bearing preload is 28 in-lb (20-35 factory spec).
The gears are new, and I used a new crush sleeve. I applied pressure to the ring gear while testing the pattern.
I'm not sure what is meant by "carryover in the pattern grease."
I do see what you mean by the sharp line in the valley. That could be a concern. I guess I was more focused on centering the pattern between the heel and toe, but, now that I look at the Yukon instruction sheet, it seems that having a nice rounded pattern is more important, even if it is slightly off center.