Intake oil leak

George Jets said
Did a 1/4" bead of RTV on the intake, after 1st putting a thin layer on both surfaces, then a 1/4" bead on the china walls.

My trick is I set the manifolds on with the cherry picker so it comes in nice and straight and level.

Then put all the bolts in and snug them up, then final torque them.

Then go back and put the final filler coat of the RTV on and smooth it out with a wet finger.

That's probably my problem. I put one bead on the china rails but none on the intake itself. I was worried about using too much. Do you still think I have a chance to get it sealed without pulling the intake? I know the back isn't going to be very easy to get to and it seems to be leaking worse than the front.