Slant 6 with an AX15?

I think I had Novak do the adapter plate, but not certain. It could have been the other place that does adapters like this (of which I can't remember their name right now). I had them leave it as a blank rather than shape the outside, I think because I didn't know where the bellhousing bolts would land. I had them put holes in to match a Mopar bearing retainer so I could center the bellhousing up on it. Ended up being a Hemi bearing adapter as it was the only one big enough to fit over the input shaft.

Here is the adapter as I got it:



Note that to make this work, I had to saw the tube off the R154 bearing retainer. Needed to keep the Toyota bearing retainer but the the Mopar bearing retainer wouldn't fit over the throw out bearing slide.

I even went and bought a Stage 3 clutch from Spec to fit the slant 6 flywheel and match the input splines on the R154.

Here is a picture of the input shaft and how far the pilot bushing adapter would have to reach:



Note that the AX15 input shaft might be a different length. This is just for reference.