My Dart Swinger Project!

More good new! (Sarcasm)
My machinist called me this morning and wanted me to come take a look at my block he finished boring them this morning ( .040 over) and two cylinders still didnt clean up. There was a pretty good size ring ridge left in the top of two cylinders. But it was only on part of it. It wasnt all the way around. He said he thought it would be ok to run but wanted me to decide if I was on with it or not. After about an hour of discussion I decided we would go .060 over. I don't want to put this much money into it and have 2 cylinders that may not seal up or loose compression or even worse catch and break a ring. So I sent my .040 pistons back and ordered the .060s this morning. Getting closer tho it's almost done.