OK, I have what was supposed to be an unused 380hp crate motor Hyd Roller cam in the shop. I was thinking about putting it in a No Buck motor, so I stuck it in V blocks and measured the lobe lift with a dial indicator. It only has .305 IN and .310 EX lobe lift, which would be about .458 IN and .465 EX with 1.5 rockers. This is a long snout Billet cam with an Iron gear pressed on.
Any Ideas on what cam this is? (bear in mind I had left my reading glasses in the house, so I could be a couple thousands off)
If i have to, I can slide it in a block and measure it later this week, Thanks for any Info.
