Cams for 318's

From the cam reveal thread
here are some similar duration cams to his fine for him choice of Engle K52

HM2103219A .483. .322 257 210 130@20 Howard-quite a bit faster ramps This is a bigger cam but I think shortest Howard shelf .904 cam
Hughes .473 .320 206 hug rejected cuz they push the envelope too hard I will not buy a cam with no seat durations too many variables
Voodoo.....454. 302 253 208 Voodoo 700 bout the same LCA different?
K-52HYD .458" .305" 254° 209° (did no one notice that Engle is at .008 like MP and Factory and Racer Brown- gotta adjust folks more like a 260 cam but a good one)
Jones........ 461 .305 256@ 202 128@ 200 actual seat is quite a bit shorter - see duration at .004 below .002 duration is shortest of everything on this page except MAYBE the Crane)
.842 ..........458 .305 272@ 216 with same lift note the extra duration it takes to get similar lobe (anyone think that 6 degrees does not make a difference)
.842 ..........434 .289 256@ 200 with same duration much less area
xe 256H ......447 .299 256 212 intake close 54 ABDC w/ 110LCA all the [email protected] w/110 lca are going to close about the same for DCA use (Jones and Crane are shorter actual seat to seat)
Summit 6400.444 ,296 280 214 Edelbrock 288SAE .004 For comparison Jones is 264 @.004 24 degrees longer seat and less lift what's not to like
Crane H202 .432 .288 [email protected] 202 113@200 Shortest Crane .904 H2 series also good wearing cam shorter than the Engle or Jones
Bullet..........432 .288 254 206 [email protected]

some notes
Me personaly only use the fast ramp cames
the Howard, Hughes, Comp with lighter 11/32 valves and beehive springs
I know for a fact that the Mike Jones " motorhome" cam was designed for the even heavier than stock BBM Motorhome valves and it wears extremely well even with these
Youu can pick up some rpm with lighter valves and springs and alonger exhaust-peronal observation
Engle also has a big nose and wears well