New electronic ignition install.....so basically the NEW BLUE WIRE....

.....the new BLUE WIRE W/yellow tracer goes to the single wire side???....correct? It goes opposite of the brown wire because that leads to the coil. No power to the key on run position, but there is power when I roll it to start. I hate wiring, any advice is appreciated and I Thankyou in advance!!

View attachment 1715581138

View attachment 1715581139

Are you just now installing this, or did it run and then quit? If you don't have power with the switch in "run" than ti's likely the bulkhead connector or ignition swtich. Have you modified anything?