New electronic ignition install.....so basically the NEW BLUE WIRE....

-

V24x2

Well-Known Member
Joined
Nov 28, 2015
Messages
381
Reaction score
214
Location
MOTORCITY
.....the new BLUE WIRE W/yellow tracer goes to the single wire side???....correct? It goes opposite of the brown wire because that leads to the coil. No power to the key on run position, but there is power when I roll it to start. I hate wiring, any advice is appreciated and I Thankyou in advance!!

06EE51E2-FDAF-4880-97CF-0B9B2B0FA8D7.jpeg


2DC48154-F832-475E-8396-39F4FECF7FB2.jpeg
 
.....the new BLUE WIRE W/yellow tracer goes to the single wire side???....correct? It goes opposite of the brown wire because that leads to the coil. No power to the key on run position, but there is power when I roll it to start. I hate wiring, any advice is appreciated and I Thankyou in advance!!

View attachment 1715581138

View attachment 1715581139

Are you just now installing this, or did it run and then quit? If you don't have power with the switch in "run" than ti's likely the bulkhead connector or ignition swtich. Have you modified anything?
 
Are you just now installing this, or did it run and then quit? If you don't have power with the switch in "run" than ti's likely the bulkhead connector or ignition swtich. Have you modified anything?
Just now installing. Car has been sitting for years so there could be a wiring issue in there somewhere. I was hoping not, buuuut there may be!
 
-
Back
Top