Project “Ghost Duster”, 1970 Duster Corner Carver
Once I had everything where I wanted it, I mig welded the inside of the brackets. These welds will be covered as I made a top plate with a couple holes that I went over with a dimple die.
This is with the top plate and j-bar laying in place. I have some more work to do but it should stiffen the front up quite a bit.
Once I had everything where I wanted it, I mig welded the inside of the brackets. These welds will be covered as I made a top plate with a couple holes that I went over with a dimple die.
This is with the top plate and j-bar laying in place. I have some more work to do but it should stiffen the front up quite a bit.
