Holley How To
A question that often comes up during reassembly.
How tight should the bowl screws be?
If you have an inch-pound torque wrench use the chart below - I think this is from an old Holley catalog.
If you don't, use the numbers to make a metal picture of x pounds hanging off the end of a wrench. For example 2 lbs hanging on 12 inch wrench would be 24 inch-lbs.
A question that often comes up during reassembly.
How tight should the bowl screws be?
If you have an inch-pound torque wrench use the chart below - I think this is from an old Holley catalog.
If you don't, use the numbers to make a metal picture of x pounds hanging off the end of a wrench. For example 2 lbs hanging on 12 inch wrench would be 24 inch-lbs.
