What type of block and headers are you using?..I can change my starter by removing just the torsion bar. I'm using a stock starter for a 96 Dodge truck which is quite small. To remove the drivers side header I have to pull the torsion bar, disconnect the tie rod end and remove the steering box. To remove or install the passenger side header I have to jack the engine up on that side. I'm using a RB block with Indy Heads and 2 inch TTIs in a 71 Demon. I'm also using the stock biscuit style K-member that came with the car. I know some fellas like using the newer 73 and up K-member that has the spool type mounts, but doesn't the spool type mounts cause the engine to sit a little lower than the biscuit style mounts?