Pertronix III set up
Okay so this morning I pulled the ignition ECU connector and traced the wires. The only ones that I cut we're the ones from the back of the ballast connectors which were the light blue with yellow and the green with red. The other three wires going from the ignition box were the black and Yellow the Brown with white and the gray to going to the old factory distributor and the other going to the negative side of the coil which are not going to be used. So it seems everything is done correctly so far leading me to the last part which is bringing the ballast wires to a single point. Based on the picture I've shown it looks like the left side has a dark blue wire and a wire that was jumping the top and bottom pin which
I assume means nothing which can be cut out and the right side has a brown wire and a small green wire going to I'm not sure if that's a capacitor or a ground meaning there's three wires left now do I cut all those off the connector and just solder them together as one?
What I started with
wires I removed nothing major was cut from any other part of the harness
The t wires I remove highlighted
This is what I'm left with wondering if they all get soldered together.
Sorry if I would like noob but electrical is not my specialty or my favorite to work with.
Okay so this morning I pulled the ignition ECU connector and traced the wires. The only ones that I cut we're the ones from the back of the ballast connectors which were the light blue with yellow and the green with red. The other three wires going from the ignition box were the black and Yellow the Brown with white and the gray to going to the old factory distributor and the other going to the negative side of the coil which are not going to be used. So it seems everything is done correctly so far leading me to the last part which is bringing the ballast wires to a single point. Based on the picture I've shown it looks like the left side has a dark blue wire and a wire that was jumping the top and bottom pin which
I assume means nothing which can be cut out and the right side has a brown wire and a small green wire going to I'm not sure if that's a capacitor or a ground meaning there's three wires left now do I cut all those off the connector and just solder them together as one?
What I started with
The t wires I remove highlighted
This is what I'm left with wondering if they all get soldered together.
Sorry if I would like noob but electrical is not my specialty or my favorite to work with.
