Trick Flow 190 Heads, hydraulic roller cam, and pushrod angle Question.

So, what if I had a 230/236/114+4 SOLID lifter cam , same .050 specs as the above HR. I have seen these with ramps advertised at 39* and less. That puts the .008 tappet rise at 64* ATDC. And now, with a Solid lifter, say the remainder of the ramps is not 12*, but say just 6*. I mean IDK; just throwing it out there. So now the Ica is 64+6=70. And lets take out say 6* for initial lash, and that leaves an Ica of just 64.... compared to 81 in the above example; that is a chitload of cylinder pressure NOT given up. And it's still the same [email protected] cam.

If I'm wrong, I want to know why.

If I'm right, I know what I would be doing;
I spent way to much money on my engine for it to generate 180/185psi, to then piss that pressure away, in an attempt to save the cost of a proper cam.