Got my RMS rear suspension kit. I am going to post pictures of how I do it & the kit. Here is some pictures of the kit as I unpacked it & the install of the main bar. I am doing this with no lift just jack stands. As you will see I cant get the car up in the air a whole lot. My garage has low ceilings. The welds are not pretty but its not going any where. The next step after this is I have to decide how much to narrow the rear end housing. The housing is from a 67 B body. If it was an A body rear im thinking of having 1.5 inches taken off each end. Once that's done I will post more pictures of the rest of the install.
RMS REAR SUSPENSION INSTALL
- Thread starter cawley
- Start date
-
According to RMS you can run up to 3 inch tail pipes except if you are running a Dana. But I have heard of people running 3 inch.
-
