Help Please
On the resister block there is 2 blue on one side ign 2 and a blue and a brown on the other . The 2 blue together on one side are key on 12 volt power ign 2. The brown on the other side is ign 1 start 12 volt power while the blue is run 8 volt when the key is on after it receives power from the other side.
The resister converts the 12 to 8 so the coil does not overheat. When cranking the car the two blue ign 2 go dead and the brown ign 1 gives the blue wire 12 volts to start directly to the coil without going through the resister. When leaving off the start position ign 1 the brown goes dead and the power then comes from the other side of the resister. Only one of the blue wires that are on one side is power, the other feeds the regulator, choke, and other key on power supplies needed. the blue on the other side goes to the coil.
On the resister block there is 2 blue on one side ign 2 and a blue and a brown on the other . The 2 blue together on one side are key on 12 volt power ign 2. The brown on the other side is ign 1 start 12 volt power while the blue is run 8 volt when the key is on after it receives power from the other side.
The resister converts the 12 to 8 so the coil does not overheat. When cranking the car the two blue ign 2 go dead and the brown ign 1 gives the blue wire 12 volts to start directly to the coil without going through the resister. When leaving off the start position ign 1 the brown goes dead and the power then comes from the other side of the resister. Only one of the blue wires that are on one side is power, the other feeds the regulator, choke, and other key on power supplies needed. the blue on the other side goes to the coil.