Cam phase suggestion advice

Hello All, new member looking for some advice. Basic build of a 318 (1986) rings and bearings sort of deal, street car. Heads have been cut .015 (checked 60cc), the block decked .020 with .028 head gaskets. Hovering around 9.8+ to 10:1. The cam is a Lunati Voodoo 702, installed dot to dot it's phasing in at 2 degrees retarded. Cam card reads intake @.050 should open 2 degrees btdc, mine comes in just a fleck after tdc. Cam card reads 108 ICL , i'm reading 110.3 ICL. Should I leave well enough alone or purchase a 2 degree offset cam key to pull it into spec? Im wondering if I leave it alone it'll work well to bleed off some cylinder pressure for street use. Also the factory pistons are flat tops with very close (in fact the intake just kisses the piston) p/v clearance, however I'll be machining minimal reliefs to suit .