Cam phase suggestion advice

RammerJammer75 said
You might also want to make sure there is enough piston crown to machine reliefs and that it won't make it too thin. I like to see at least .080" clearance on the intake, and with yours "kissing" the piston you're looking at taking at least 0.085" off the piston.

Yes, the piston crown measures in at .340 thick at its thinnest point, plenty of material to play with. Also I forgot to mention, the p/v clearance was done with out the head gasket. However as pointed out the cam should be installed as listed, so that with throw the intake valve out a little sooner. I will definitely push up the clearance! Another question; I see Mr gasket has a 4 degree offset crankshaft key available that will give me my 2 degrees advance I need but I assume that puts the harmonic balancer out 4 degrees correct? The cam key is a standard woodruff size so I'll hunt for an offset one as well or perhaps machine one up; anyone know what the offset dimension is for 2 degrees?
I just looked again, my bad, the Mr Gasket offset key is for the camshaft. The Woodruff key is the standard #606. Anyone have a Mr G 987 key by chance?