Deck Lid and Interior Questions

Find a bushing such as a deep well socket that fits one of the holes in the inner panel. Lightly put a center punch or pencil mark going through the socket with a transfer punch or marker. Do this with a center punch just enough to see on the outside of the decklid if you need to drill from the outside. If the inner is shallow enough drill them from the inside just using the pencil mark. Once you have a single locating hole you can locate the rest using the emblem from the outside of the panel.

I use this same method for installing factory scoops and other items. This will locate the part to the access holes to apply the fasteners. After one or two holes are located the rest can be done from the outside of the panel using the part. No measurements or drill pattern is needed if done this way. I always find a bushing or another source to fit the hole laying around to use to find center using the inner access holes. Good luck Steve
.