No spark after ingition module replacement

Ballast resister is good as proved by the old unit working.

My bet is the replacement until has pins that are a tad smaller in diameter than the OEM unit. The old connector has lost its tension and is not making contact on at least 1 pin.

You could use jumpers and prove that out. Or you could try to tighten the receiving connectors in the plug.


Lastly. You could CAREFULLY remove as much of the goo as you can and but some "pottant" from amazon

Like this
https://www.amazon.com/dp/B07NDMD2KR/?tag=fabo03-20

But the dp270 requires an applicator gun, but you could rig something up