Pro Parts Headers???

72Duster440 said
I just went and snapped this pic, I dont have one that showed a general shot of them.

My frame in that area is 6" off the ground, the collector tube is 3" and the bottom of the flange is 2.5". It drags a lot, and it currently sealed with 2 gaskets and a tube of copper RTV. Lol

Let me know if other pictures would help, access is limited since theres not much clearance, but I can try!

Edit: I measured at about the midpoint from where the tubes merge and the collector flange is.

View attachment 1715616218

Thank you. This helps a lot! Any idea how far back the #7 tube goes relative to the engine/trans surface? Looks like that one would cause some serious interference issues with my midplate. I think using photos of the basic layout of this style of headers will be my basis for building a set. Should work out great. Thanks again.