Aligning door

In order to close the gap at the bottom rear of the door, the top hinge would need to be bumped out a smidge, and the lower hing would need to be bumped in. If there is any change to the front margins, loosen the top fender bolt that is hidden between the door and the fender and readjust that until you’re satisfied. Then go to the bottom of the fender and loosen that pair of bolts and adjust the margins there, which must be done with body shims. Use OMM’s advise on the stops, and work in very small increments, a little at one end adds up to a lot at the other end.