How bad is this?
If you look close at the orange Duster you can see where the corner of the quarter was drilled top and bottom and the holes were welded back in. I drilled the corner of two short pieces of angle iron. I put it behind the end of the quarter. I then put an eye bolt through the quarter and pulled the angle. This Duster was worse then yours. The trunk lid was out past the tail panel almost 1-2 inches. That is the original tail panel and the quarters . My brown Duster was hit the same way on one side like yours. When they are bent like the last pictures there is no hope. A little more than the " 3mm. tolerance would allow. LOL
![DSCF0047[1].jpg](https://www.forabodiesonly.com/mopar/attachments/dscf0047-1-jpg.1715627231/ "DSCF0047[1].jpg")
If you look close at the orange Duster you can see where the corner of the quarter was drilled top and bottom and the holes were welded back in. I drilled the corner of two short pieces of angle iron. I put it behind the end of the quarter. I then put an eye bolt through the quarter and pulled the angle. This Duster was worse then yours. The trunk lid was out past the tail panel almost 1-2 inches. That is the original tail panel and the quarters . My brown Duster was hit the same way on one side like yours. When they are bent like the last pictures there is no hope. A little more than the " 3mm. tolerance would allow. LOL