Quick fuel carb fuel pressure too high? Rich idle...

cawcislo said
Okay tapped the new holes in my metering block, that was pretty easy with the spiral flute tap I bought. Had to enlarge the area around the tapped hole as the idle feed restrictors need a bit more room to screw them in. So I got it done. But are they low enough. Not much clearance between them and the gasket that will be installed. Let me know what you think.

View attachment 1715626684

View attachment 1715626685

Perfect. The only thing I will mention is if you don’t want to do the extra clearance work for the jets with the screwdriver head on them, you just use brass 6-32 x .125 long set screws.

Otherwise, you did good. And that’s not wrong what you did, just a bit more work if you like the screwdriver headed jets better, use them.