Lift he car front up on both sides and support with Jack stands. The height adjustment bolt that is in the middle of the lower control arm will raise or lower the car dramatically! At 2 or 3 turns. Try 1 full turn Precisely.
Once the car is in the ground, bounce the front end up and down a good 5 or 6 times to get everything settled in good.
When you measure the height via the front fenders, use the tape measure at the tires center to the middle of the wheel and up to the fender. Mark it with a pencil line and write the height down. Go to the other side.
You can adjust each side. IF you can weigh down the drivers seat with your body’s weight, free lifting weights are great for this, you can then get both sides at a equal height as driven.
A good look height is when there is about less than an inch of clearance from the top of the tire to the fender lip. This is about where you want to start and probably end up when you’re finished.
