Engine Swap on A108?

I would disassemble the trans for the big block to a bare housing, bolt up the tail shaft housing from the small block trans, then bolt it to the engine. Hang it from the trans mount, then put the block at whatever height is required for clearance of ALL areas that may conflict with the doghouse: valve covers, head exhaust flanges and the exhaust headers or manifolds you intend on using, and most importantly intake, carb, any carb spacer you might consider, and an air cleaner. Might have to modify those brackets by cutting down and/or redrilling holes, even use thicker or thinner rubber mounts. Oh, and your putting that 400 in so get to mocking it up!! :thumbsup: