Stop in for a cup of coffee

-
Camshafts are black magic to me. I only care if the damn things run...
 
14EC23DD-8A27-4A98-8FE1-139DF4E24781.png
 
Seems like a big cam for a small block, but I’m no expert but I know the 440’s cam is a .510/.514, I forget the rest, I’ll have to look it up in the morning
Nope very mild. @050 duration is only in the 210/220 range with a 112° lobe separation. The lift is just a tick over .500 and a roller can handle that easily. (even with stock heads and valve springs. They don't coil bind till .525 or better.) Note the rpm range. 900-5200rpm.
 
I would have called Oregon cam grinders and had them set ya up with one custom. Cost would have been a little less, but it’d been speced to your ride. Especially with the gear vendors
I have been pulling out my hair to figure out a cam. Had to decide eventually.....
 
-
Back
Top