If you can’t buy it....MAKE IT!!
If you can’t buy it, make it! Needed an adapter to go from 1/8-27NPT to 7/16-20 standard. Pretty much doesn’t exist, and my lathe is down, so I improvised.
....and then break it upon the initial test fit.
Unfortunately I went too far below the hex head and that weakened the part.
If you can’t buy it, make it! Needed an adapter to go from 1/8-27NPT to 7/16-20 standard. Pretty much doesn’t exist, and my lathe is down, so I improvised.
....and then break it upon the initial test fit.
Unfortunately I went too far below the hex head and that weakened the part.
