Carbon fiber dash pad.
Then I did a second epoxy coat.
at this point the foam is rigid and I can begin to add filler and shape the piece.
Now I’m ready for a layer of fiberglass
Then I blocked the fiberglass
Then I prepped the final carbon layer.
Here it is ready for a layer of epoxy
then I let it sit till epoxy was tacky but not cured. This is important because it needs to grab the carbon.
Then I applied the carbon.
I let that sit for 3hrs and put top coat of resin.
at this point I need to let it cure for 24hrs. And lightly sand it. Then I need to put 3 coats of clear and I can block it and final coat it.
Print