I'm stickin by Rustoleum. It's cheap and very effective.
Surface rust prep before sound deadning
- Thread starter 67notchb
- Start date
-
Cudabnu
(3) 64 Val Verts. /6 4spd, 273/904, 318/727
After replacing the rear 1/2 of the floor pan, we wire wheeled the pan, used POR -Patch as a seem sealer and coated the pan in POR-15 then the fat mat.
67notchb
Well-Known Member
That looks really good. How much did it take to do the floors front and back?
Cudabnu
(3) 64 Val Verts. /6 4spd, 273/904, 318/727
I had a 50sq ft roll that I used, didn't use it all! For my other 64 I used 36sqft of this: https://www.amazon.com/dp/B00URUIKAK/?tag=fabo03-20
Dartsun
Mopar Dude
I used the noico 36ft sound deadening I liked the way it went down. Bought a roller also. I used the rustoleum rust converter on the floor boards. I still haven’t drove the car with the sound deadening though.
adamm
Well-Known Member
I went the route of comfort:
- Firewall to bare metal
- Rustoleum primer
- Herculiner
- Noico 80 mil car Sound deadening mat, Butyl Automotive Sound Deadener
- Noico RED 315 mil (8mm)
Noico was by far the the most cost effective and had great reviews both on this site and amazon. I've taped the seams since and did a little more clean up but don't have pictures yet. I didn't buy the roller and had no problems installing the Noico deadening mat with a scrap piece of wood that I took the edges off of.
- Firewall to bare metal
- Rustoleum primer
- Herculiner
- Noico 80 mil car Sound deadening mat, Butyl Automotive Sound Deadener
- Noico RED 315 mil (8mm)
Noico was by far the the most cost effective and had great reviews both on this site and amazon. I've taped the seams since and did a little more clean up but don't have pictures yet. I didn't buy the roller and had no problems installing the Noico deadening mat with a scrap piece of wood that I took the edges off of.
Clean floor with wire cup on grinder, wipe with wax/grease remover from the "real" paint store, epoxy prime if you are fancy, topcoat that with Rusteoleum or SS urethane. Too cheap for carpet? Then spray a coat of BodySchltz over it.
Works for me.
Works for me.
-
