Camshaft choice for 408 Magnum w/ boost plans
6PSI of boost and a 150 shot of spray coupled with excessive RPM’s (7,000+) don’t do well with hyper skirts.
I’ve never burned a piston or popped the crown from a butted ring land.
I’ll have to try out these KB 356 pistons.
How much did you mill off the pistons?
Looks like I’ll need to mill off 7cc worth of volume across a 4.030 diameter.
And, yes, I stayed at or below 30* total timing with non projected tip spark plugs.
What’s your preference on main bearings, half groove or full groove for full time oiling to the rod bearings?
How much boost were you running??
TIA Cheers!
6PSI of boost and a 150 shot of spray coupled with excessive RPM’s (7,000+) don’t do well with hyper skirts.
I’ve never burned a piston or popped the crown from a butted ring land.
I’ll have to try out these KB 356 pistons.
How much did you mill off the pistons?
Looks like I’ll need to mill off 7cc worth of volume across a 4.030 diameter.
And, yes, I stayed at or below 30* total timing with non projected tip spark plugs.
What’s your preference on main bearings, half groove or full groove for full time oiling to the rod bearings?
How much boost were you running??
TIA Cheers!
